Construction Equipment in General and Gear Lubrication

While one should  not go contrary  to the  recommendations of the  supplier of construction equipment, practically all enclosed gears  on such  machinery  can  no  doubt  be  serviced with SAE 80  or SAE 90  EP or  MP gear oil. An  exception  are  worm  drives which should be  lubricated with a  compounded  oil  of SAE  140  grade. The use of certain mild EP oils is permissible for the lubrication of worm drives provided the oil supplier so advises. Air and oil filters require the same attention as in the case of tractors. Also drain periods on any construction equipment should be established at a maximum of 1000 hours. It is best to drain immediately after operating and while the gear boxes are warm. If the discarded lubricant is very dirty, flushing of the gear compartments before adding fresh oil is desirable. Open gears will be found on many pieces of construction equipment. For example, large shovels, cranes, drag lines, concrete mixers, etc. The  recommended lubricant for  such  gears is a residual  type  having  a  viscosity of 1000 SUS  at  210 degree F for cold  weather  and 2000 for  warm  weather. If the machinery  is to be used  under wet  conditions, the lubricant should  contain additive which  will  insure that  the oil  adhere to gear  surfaces  when  water is present. Better  still  these  open  gear lubricants  should contain both  EP  and  rust  inhibiting additives. Exposed gears are lubricated as required, often on each eight hour shift. If  railroad  equipment  is used  in  construction, the  tractor  motor gears  can be lubricated  with  the heavier  grade of open  gear oil.