Showing posts with label gravity. Show all posts
Showing posts with label gravity. Show all posts

Monday, November 12, 2012

Characteristics of lubricating oils

,

Specifications for lubricating oils commonly include all or some of the following values:
        (1)   Gravity
        (2)   Flash Point
        (3)  Fire Point
        (4)    Viscosity
        (5)   Viscosity Index (V.I)
        (6)    Pour Point
        (7)    Carbon Residue
         (8)    Color
        (9)    Neutralization Number
In  addition  certain other  characteristics  or  tests  will  be mentioned as  these  are  sometimes called for  and   hence  may  me  be of  value in  determining the  suitability of an oil  for  certain purposes. Some such qualities are:  Aniline Point; Ash; Corrosion Characteristics or Protection; Precipitation Number; and Steam Emulsion Number.
Methods  for  conducting  tests to  determine  values for  oil  characteristics  have been  standardized  by  American  Society  for  Testing  and  Materials  ( ASTM)  and  in many  cases  the  methods  are  in general  agreement with  Institute  of  Petroleum (IP)  and  U.S. Government  Methods as   shown  in  Federal  Test  Method  Standard  No. 791.
In  the  details to follow ASTM and  IP numbers for  methods of  test will  be given followed by  a short description  of what  the  test consists of. Also,  where  possible  the  significance of  such  qualities or  tests, as  they influence the  selection and use  of an oil for gear  lubricants, will be  noted.  

Friday, June 1, 2012

Dripfeed Gear Lubrication

,

Dripfeed application of gear oils may be considered semi-automatic in that it is adjustable to a certain degree. The feed for the oil in this case may be by gravity or even by circulation if the stream in the latter instance can be throttled down sufficiently. In the first case a container can be filled by hand or even a small drum can be connected with piping ending in a valve or cock to permit adjustment of the feed. Here, as the amount of oil in the container becomes less, the feed will decrease. Where such a feed is partly mechanical, the oil will come either from a storage tank to which a pump has delivered it or directly from a circulating line. In either case the amount of used can be calibrated.
While dripfeed can be applied to enclosed gearing it is more often used on open gearing. Here it is applicable to softer types of gear oils including cut back types. This is more desirable method of lubricating open gears than the methods previously mentioned. Also, in case cut back gear oil is used, any vapor from the same will escape slowly and hence will be less of a hazard than if the mixture were sprayed on. Further, there are fewer tendencies to over lubricate by a drip method than with other methods of hand application. Therefore, there is a consequent reduction in waste and poor housekeeping.
 

Gear and Transmission Lubricants Copyright © 2011 | Template design by O Pregador | Powered by Blogger Templates