The Navy Gear Wear Tester

The Navy Gear Wear Tester is described in Federal Methods 791, Methods 335. The  equipment  makes  use  of  small  brass and  steel  gears,  but  Ninos  has  also  used  mating  gears  of other metals, such  as  brass on  stainless  steel, Phosphor  Bronze, and  ST Aluminum   on  SAE     4130 steel  and  SAE B-1112  steel  against  stainless  steel.

In  the  test  two  helical  gears  of  dissimilar  metals, each  approximately  one half inch  in  diameter are  rotated  together  as the  driving  motor  delivers a simple  harmonic motion     of 4.0  inches  amplitude  and  40 cycles per minute, through a  crack  to  the  upper  brass gear. This gear  oscillates  approximately  one  revolution while  a torque load of about  three  and  one  half inch pounds  is applied to  the  test  gears by  means  of a seven  pound  weight. The  gears  are  oscillated  for the  desired  number  of  cycles, or until gear  tooth  failure  due  to  excessive  wear  occurs. At the completion of the test, the gears are removed from the fixture, cleaned as before, and reweighed to    determine weight loss. The wear rate in mg for 10,000 cycles is then calculated permitting a comparison of different lubricants. New  test  gears  are  used  for  each  run even  though  there  is  virtually  no wear  of the  steel  gear  as  compared  to the  brass  gear.

Both fluid products and lubricating greases can be tested as gear lubricants on this apparatus. Indications  are  that  with  increase  in viscosity  of  gear  oils  the  gear wear   decreases. No  speculations are  given  as to how  much  of    the  wear  might  be  due  to abrasion which  is due  to particles  from  the gears.

Nonferrous Gears and Their Lubrication

While the tendency is to think only of gears made of ferrous metals, we find in Dudley^16 the statement: “A wide variety of bronzes, aluminum alloys, zinc alloys, and nonmetallic plastics and laminates are used to make gears.”

Fortunately, well refined mineral oils have little action on most of the combinations. We say  combinations  because in  many  cases the nonferrous  gear is driven by a  steel pinion, but when the loads are light and the  gears are small, both members  may be of the nonferrous  material.

Nonreactive oils should be used with nonferrous gears unless specific recommendations state otherwise. This is illustrated in the case of worm gears where the gear is normally made of bronze. The  general  recommendation for  such units is a mineral  oil  containing  tallow, although  often  such  oils  contain  lead  soaps  and  occasionally certain EP agents.

Synthetic fluids, both diesters and “Ucon fluids, have been used as lubricants with nonferrous or ferrous and nonferrous combinations of gears. Where a problem of lubricating  an  unusual combination of  gear  materials is  encountered, the manufacturer of  the gear set should  be  able to  make a safe  recommendation. However, lacking a  suggestion, a well  refined  lubricating  oil  with no reactive additives  present  can  generally be used with safety in the  case of  nonferrous  gear sets.